Product Features
Ø Hot-Pluggable
Ø PIN receiver
Ø Up to 2.67Gb/s Data Links
Ø Duplex LC connector
Ø Maximum Power <1W
Ø Up to 80km on 9/125μm SMF
Ø CWDM DFB laser transmitter
Ø Single +3.3V Power Supply
Ø Monitoring Interface Compliant with SFF-8472
Ø Commercial operating temperature range: -0°C to 70°C
Ø RoHS compliant and Lead Free
Applications
Ø Gigabit Ethernet
Ø 1x/2xFibre Channel
Ø SONET OC-48 / SDH STM -16
Ø SONET OC-12 / SDH STM -4
Ø SONET OC-3 / SDH STM -1
Absolute Maximum Ratings
Table 1-Absolute Maximum Ratings
|
Parameter |
Symbol |
Min |
Max |
Unit |
Note |
|
Storage Temperature |
TS |
-40 |
85 |
°C |
|
|
Operating Case Temperature |
TOP |
0 |
70 |
°C |
|
|
Power Supply Voltage |
VCC |
-0.5 |
4 |
V |
|
|
Relative Humidity (non-condensation) |
RH |
0 |
85 |
% |
|
Note:
It has to be noted that the operation in excess of any individual absolute maximum ratings might cause permanent damage to this module.
Recommended Operating Conditions
Table 2 -Recommended Operating Conditions
|
Parameter |
Symbol |
Min |
Typical |
Max |
Unit |
Note |
|
Operating Case Temperature |
TOP |
0 |
|
70 |
°C |
|
|
Power Supply Voltage |
VCC |
3.135 |
3.3 |
3.465 |
V |
|
|
Power Consumption |
P |
|
|
1 |
W |
|
|
Supply Current |
Icc |
|
|
300 |
mA |
|
|
Data Rate |
BRAVE |
- |
2.5 |
2.67 |
Gb/s |
|
|
Bit Error Rate |
BER |
|
|
10-12 |
|
|
|
Max. Supported Link Length on 9/125μm SMF @ OC-48/STM-16 |
LMAX1 |
|
80 |
|
km |
|
|
Max. Supported Link Length on 9/125μm SMF @ 2xFibre channel |
LMAX2 |
|
80 |
|
km |
|
|
Max. Supported Link Length on 9/125μm SMF @ Gigabit Ethernet |
LMAX3 |
|
80 |
|
km |
|
|
Max. Supported Link Length on 9/125μm SMF @ OC-12/STM-4 |
LMAX4 |
|
100 |
|
km |
|
|
Max. Supported Link Length on 9/125μm SMF @ OC-4/STM-1 |
LMAX5 |
|
100 |
|
km |
|
Optical Characteristics
Table 3 -Optical Characteristics
|
Parameter |
Symbol |
Min. |
Typical |
Max. |
Unit |
Note |
|
Transmitter Section: |
||||||
|
Center Wavelength |
λc |
-6.5 |
CWDM |
+6.5 |
nm |
|
|
Spectral Width@-20dBm |
σ |
|
|
1 |
nm |
|
|
Sidemode Supression ratio |
SSRmin |
30 |
|
|
dB |
|
|
Optical Output Power |
Pout |
1 |
|
5 |
dBm |
1 |
|
Extinction Ratio |
ER |
8.2 |
|
|
dB |
|
|
Optical Rise/Fall Time |
tr / tf |
|
|
260 |
ps |
2 |
|
Relative Intensity Noise |
RIN |
|
|
-120 |
dB/Hz |
|
|
Total Generated Transmitter Jitter (peak to peak) |
JTXp-p |
|
|
0.07 |
UI |
|
|
Total Generated Transmitter Jitter (rms) |
JTXrms |
|
|
0.007 |
UI |
|
|
Output Eye Mask |
Compliant with eye mask Telcordia GR-253-GORE |
|
||||
|
Receiver Section |
||||||
|
Optical Input Wavelength |
λc |
1470 |
|
1610 |
nm |
|
|
RX Sensitivity @ OC-48/STM-16 |
Sen1 |
|
|
-27 |
dBm |
3 |
|
RX Sensitivity @ 2xFibre channel |
Sen2 |
|
|
-27 |
dBm |
4 |
|
RX Sensitivity @ Gigabit Ethernet |
Sen3 |
|
|
-27 |
dBm |
4 |
|
RX Sensitivity @ OC-12/STM-4 |
Sen4 |
|
|
-32 |
dBm |
5 |
|
RX Sensitivity @ OC-4/STM-1 |
Sen5 |
|
|
-32 |
dBm |
5 |
|
RX_LOS Assert |
LOS A |
-42 |
|
|
dBm |
|
|
RX_LOS De-assert |
LOS D |
|
|
-28 |
dBm |
|
|
RX_LOS Hysteresis |
LOS H |
0.5 |
|
|
dB |
|
|
Receiver Overload |
Pol |
|
|
3 |
dBm |
|
Note:
1、Compliant with FDA/CDRH and EN (IEC) 60825 regulations (Class 1 Laser Safety).
2、20-80%.
3、Measured with PRBS 231-1 at 10-12 BER
4、Measured with PRBS 27-1 at 10-12 BER
Electrical Characteristics
The following electrical characteristics are defined over the recommended operating environment
Table 4 -Electrical Characteristics
|
Parameter |
Symbol |
Min. |
Typical |
Max. |
Unit |
Note |
|
Transmitter Section |
||||||
|
Input differential impedance |
Rin |
90 |
100 |
110 |
W |
1 |
|
Single ended data input swing |
Vin PP |
250 |
|
1200 |
mVp-p |
|
|
Transmit Disable Voltage |
VD |
Vcc – 1.3 |
|
Vcc |
V |
2 |
|
Transmit Enable Voltage |
VEN |
Vee |
|
Vee+ 0.8 |
V |
|
|
Transmit Disable Assert Time |
Tdessert |
|
|
10 |
us |
|
|
Receiver Section |
||||||
|
Single ended data output swing |
Vout,pp |
300 |
|
800 |
mv |
3 |
|
LOS Fault |
Vlosfault |
Vcc – 0.5 |
|
VCC_host |
V |
5 |
|
LOS Normal |
Vlos norm |
Vee |
|
Vee+0.5 |
V |
5 |
|
Power Supply Rejection |
PSR |
100 |
|
|
mVpp |
6 |
Note:
1、AC coupled.
2、Or open circuit.
3、Into 100 ohm differential termination.
4、20 – 80 %
5、LOS is LVTTL. Logic 0 indicates normal operation; logic 1 indicates no signal detected.
6、All transceiver specifications are compliant with a power supply sinusoidal modulation of 20 Hz to 1.5MHz up to specified value applied through the power supply filtering network shown on page 23 of the Small Form-factor Pluggable (SFP) Transceiver Multi-Source Agreement (MSA), September 14, 2000.
Digital Diagnostics
Table5 -Digital Diagnostics
|
Parameter |
Symbol |
Min |
Max |
Unit |
Note |
|
Temperature Monitor Absolute Error |
DMI_Temp |
-3 |
3 |
°C |
Cover full operating temperature range |
|
Supply Voltage Monitor Absolute Error |
DMI _VCC |
-0.1 |
0.1 |
V |
Cover full operating temperature range |
|
Channel RX Power Monitor Absolute Error |
DMI_RX_Ch |
-3 |
3 |
dB |
|
|
Channel Bias Current Monitor |
DMI_Ibias_Ch |
-10% |
10% |
|
|
|
Channel TX Power Monitor Absolute Error |
DMI_TX_Ch |
-3 |
3 |
dB |
|
If you need more support , Please contact us .
